Envoy 4WD V8-5.3L VIN M (2005)
4. If replacing only the driver door module, remove the module from the door trim panel.
5. Disconnect the remaining electrical connectors from the switch panel.
6. If replacing only the switch panel, retain the driver door module for transfer.
7. Remove the switch panel assembly from the vehicle
INSTALLATION PROCEDURE
1. Install the driver door module (1) to the door trim panel.
2. Connect the electrical connector to the driver door module.
3. If replacing the switch panel, connect the remaining electrical connectors.
4. If replacing the driver door module, program the driver door module. Refer to Service Programming System (SPS) in Programming and
Personalization Description and Operation in Personalization.
IMPORTANT: When replacing the driver door module, the set up procedure must be performed.
5. Install the switch panel to the door trim panel, ensuring the front and rear retaining clips are fully seated.
Switch Replacement - Door Lock and Side Window - Passenger
SWITCH REPLACEMENT - DOOR LOCK AND SIDE WINDOW - PASSENGER
REMOVAL PROCEDURE
1. Lift up on the front edge of the switch panel in order to release the front retaining clip.
2. Lift up on the rear edge of the switch panel in order to release the 2 rear retaining clips.
3. If equipped, disconnect the electrical connectors from the passenger door module (1).
4. If replacing only the passenger door module, remove the module from the door trim panel.
5. Disconnect the remaining electrical connectors from the switch panel.
6. If replacing only the switch panel, retain the passenger door module for transfer.
7. Remove the switch panel assembly from the vehicle.
INSTALLATION PROCEDURE
1. Install the passenger door module (1) to the door trim panel.
2. Connect the electrical connector to the passenger door module.
3. If replacing the switch panel, connect the remaining electrical connectors.
