Envoy 4WD V8-5.3L VIN M (2005)
Steering Gear: Service and Repair
Power Steering Gear Replacement
Power Steering Gear Replacement
Tools Required
^
J24319-B Steering Linkage and Tie Rod Puller
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Install a drain pan under the vehicle.
3. Remove the tires and wheels.
4. Remove the outer tie rods retaining nuts.
5. Notice: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result
which will cause premature failure of the joint.
Disconnect the outer tie rods from the steering knuckles using J24319-B.
6. Remove the steering gear crossmember.
7. Disconnect the lower intermediate shaft from the power steering gear.
8. Remove the power steering hose assembly to the power steering gear retaining bolt.
9. Remove the power steering hose assembly from the power steering gear.
10. Support the power steering gear.
