Envoy 4WD V8-5.3L VIN M (2005)
Stabilizer Bushing: Service and Repair
Front
Stabilizer Shaft Insulator Replacement
Removal Procedure
1. Raise the and support the vehicle. Refer to Vehicle Lifting.
2. Remove the stabilizer shaft insulator clamp mounting bolts.
3. Remove the stabilizer shaft insulator clamp from the stabilizer shaft insulator.
4. Lower the stabilizer shaft and remove the stabilizer shaft insulator.
Installation Procedure
1. Install the stabilizer shaft insulator to stabilizer shaft with slit facing the front of the vehicle.
2. Install the stabilizer shaft insulator clamp to the stabilizer shaft insulator.
3. Install the stabilizer shaft insulator clamp mounting bolts.
Tighten
Tighten the stabilizer shaft insulator clamp mounting bolts to 55 Nm (41 ft. lbs.).
Notice: Refer to Fastener in Service Precautions.
4. Lower the vehicle.
