Envoy 4WD V8-5.3L VIN M (2005)
Pry the yoke away from the control arm to install the J 36607.
6. Remove the J 36607 and the shock module yoke to lower control arm retaining nut.
7. Remove the shock module from the shock tower and lower control arm.
Installation Procedure
1. Install the shock module to the shock tower and lower control arm.
2. Install the shock module yoke to the lower control arm.
3. Lower the vehicle.
4. Install the shock module upper retaining nuts.
Tighten
Tighten the shock module upper retaining nuts to 45 Nm (33 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
5. Raise the vehicle.
