Envoy 4WD V8-5.3L VIN M (2005)
Shifter A/T: Service and Repair
Floor Shift Control Knob Replacement
Removal Procedure
1. The floor shift control knob and boot are serviced as an assembly.
2. Loosen the set screw (3) or (1) for Oldsmobile models.
3. Push in at the base of the boot to release the locking tabs (2) from the console assembly.
4. Pull up to remove the knob and boot assembly from the transmission control (4).
Installation Procedure
1. Install the knob and boot assembly onto the transmission control (4).
2. Notice: Refer to Fastener Notice in Service Precautions.
Engage the locking tabs (2) with the console assembly.
Tighten the control knob set screw (1 or 3) to 2 Nm (18 inch lbs.).
