Envoy 4WD V8-5.3L VIN M (2005)
7. Install the window regulator.
8. Install the water deflector.
9. Install the outer window belt sealing strip.
10. Install the inner window belt sealing strip.
11. Install the trim panel.
Window Weatherstrip Run Channel Assembly Replacement - Rear (TrailBlazer, Envoy, Bravada)
Window Weatherstrip Run Channel Assembly Replacement - Rear (TrailBlazer, Envoy, Bravada)
Removal Procedure
1. Remove the trim panel.
2. Remove the inner window belt sealing strip.
3. Remove the outer window belt sealing strip.
4. Remove the water deflector.
5. Remove the window.
6. Remove the bolt that retains the weatherstrip run channel to the door.
7. Pull the weatherstrip/run channel from the window frame opening.
8. carefully release the double sided tape attaching the molding to the outside of the door.
9. Carefully twist the weatherstrip run channel and pull up at the top of the door frame.
Important: The quarter glass and weatherstrip/run channel is not serviceable and should be replaced only as an assembly.
10. Remove the weatherstrip/run channel from the door.
Installation Procedure
1. Install the weatherstrip/run channel to the door.
2. Press the weatherstrip/run channel into the window frame opening.
3. Position the tabs on the weatherstrip/run channel into the slots on the door.
4. Attach the molding to the outside of the door with double sided tape.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the weatherstrip/run channel retaining bolt.
Tighten the bolt to 10 N.m (88 lb in).
6. Install the window.
7. Install the water deflector.
8. Install the outer window belt sealing strip.
9. Install the inner window belt sealing strip.
10. Install the trim panel.
