Envoy 4WD V8-5.3L VIN M (2005)
2. Remove the end gate interior trim panel.
3. Remove the washer hose and grommet from the end gate outer panel.
4. Remove the end gate wiring harness from the end gate.
5. Cut the rear washer hose ends where the hose ends break out of the harness.
INSTALLATION PROCEDURE
1. Route the rear washer hose along the wiring harness.
2. Tape the rear washer hose to the wiring harness with 3 wraps of electrical tape at points no more than 100 mm (4 in) apart from each other.
3. Install the end gate wiring harness to the end gate.
4. Install the rear washer hose and grommet to the end gate outer panel.
5. Install the end gate interior trim panel.
