Envoy 4WD V8-5.3L VIN M (2005)
6. Remove the wiper arm blade (1) from the wiper arm (2), if necessary.
INSTALLATION PROCEDURE
1. Install the wiper arm blade (3) to the wiper arm (1), if removed.
2. Turn the ignition to the RUN position, engine OFF.
3. Turn the wiper switch to position 3, full speed.
4. Locate and remove the rear wiper fuse, fuse number 9, located under the LH rear seat.
5. Turn the wiper switch to the OFF position.
6. Reinstall the fuse in the fuse block number 9 position.
7. Turn the ignition to the LOCK position.
8. Install the washer hose end fitting and position the washer hose clockwise around the pivot shaft and connect to the elbow.
9. Install the rear wiper arm. Align the park finger of the arm into the park pocket in applique.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the nut to 6-10 N.m (55-89 lb in).
