Envoy 4WD V8-5.3L VIN P (2004)
1. Position the fascia to the vehicle, ensuring that the body side attachment tabs are fully seated.
2. Install the 4 push-pins that retain the bottom of the fascia to the headlamp housing panel.
3. Install the push-pins (3) that retain the fascia to the fascia support rods (2).
4. Install the air defector.
5. Install the cornering lamps.
6. Install the fog lamps.
Notice: Refer to Fastener Notice in Service Precautions.
8. Install the 2 bolts that retain the top of the fascia to the headlamp housing panel.
Tighten the bolts to 10 N.m (89 lb in).
9. Install the push-pin that retains the center of the top of the fascia to the headlamp housing panel.
10. Install the grille.
