Envoy 4WD V8-5.3L VIN P (2004)
8. Partially remove the trim panel in order to remove the inflator switch from the inflator bezel.
9. Remove the auxiliary air outlet washer and retaining nut.
10. Feed the auxiliary air outlet through the inflator bezel.
11. Remove the inflator bezel from the trim panel.
12. Disconnect the 12-volt power supply electrical connector.
13. Remove the trim panel from the vehicle.
Installation Procedure
1. Position the trim panel to the vehicle.
2. Connect the 12-volt power supply electrical connector.
3. Install the inflator bezel to the trim panel.
4. Feed the auxiliary air outlet through the hole in the inflator bezel.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the auxiliary air outlet washer and retaining nut.
Tighten the nut to 2 N.m (18 lb in).
6. Install the inflator switch to the inflator bezel.
7. Position the seat belt over the top of the trim panel, ensuring that the buckle is not behind the trim panel.
8. Align the locating tabs on the trim panel to the holes in the body.
9. Seat the clips that retain the trim panel to the body.
10. Install the seat belt lower anchor.
Tighten the anchor bolt to 70.0 N.m (52 lb ft).
11. Install the right rear door sill panel.
12. Install the lift gate sill plate.
13. Install the trim panel-rear quarter upper.
Trim Panel Replacement - Rear Quarter Upper (Short Wheelbase)
TRIM PANEL REPLACEMENT - REAR QUARTER UPPER (SHORT WHEELBASE)
REMOVAL PROCEDURE
