Envoy 4WD V8-5.3L VIN P (2004)
3. Install the 3 bolts that retain the head restraint retractor assembly to the seat back frame.
Tighten the head restraint retractor bolts to 10 N.m (88 lb in).
4. Install the seat back cover and pad.
Head Restraint Guide Assembly Replacement - Rear No. 2
Head Restraint Guide Assembly Replacement - Rear No. 2
Removal Procedure
1. Remove the head restraint assembly.
2. Remove the seat back cover and pad to expose the seat back frame.
3. Gently pull the pad away from the seat back frame. It may be glued in places from its original assembly.
4. Remove the head rest restraint guides by squeezing the tabs on the bottom of the guide together and pulling the guide upward out of the seat.
Installation Procedure
1. Install the head restraint guides by pushing them through the cover into the frame until the locking tabs snap into place. The guide with the locking
tab (1) installs on the right hand side of the seat.
2. Install the seat back cover and pad on the seat back frame.
3. Install the head restraint assembly.
