Envoy 4WD V8-5.3L VIN P (2004)
5. Rotate the crankshaft until two opposing flywheel bolt holes are parallel to the oil pan surface.
Important: The tapered legs of the alignment tool must enter the rear cover oil seal bore.
6. Install the J 41476 and bolts onto the rear of the crankshaft.
NOTICE:
Refer to Fastener Notice in Service Precautions.
7. Tighten the J 41476 mounting bolts until snug. Do not overtighten.
7.1.
Tighten the oil pan-to-rear cover bolts to 12 Nm (106 inch lbs.).
7.2.
Tighten the engine rear cover bolts to 25 Nm (18 ft. lbs.).
8. Remove the J 41476.
9. Install a NEW crankshaft rear oil seal.
10. Install the engine flywheel.
