Envoy 4WD V8-5.3L VIN P (2004)
8. Loosen the air spring level sensor to the frame mounting bolts.
Important: If not equipped, use a new anti-rotation bolt (P/N 11569736).
9. Loosely install the sensor mounting bolts with the anti-rotation bolt in the right hand mounting hole.
Notice: Refer to Fastener Notice in the Preface section.
Important: Do not remove the air spring level sensor locating pin until the air spring level sensor has been properly mounted and aligned.
10. Install the air spring level locating pin.
A 4 mm drill bit or equivalent can be substituted.
Tighten
1. While holding the body of the sensor, tighten the anti-rotation bolt first.
2. Tighten the air spring level sensor frame mounting bolts to 8 Nm (71 lb in).
