Envoy 4WD V8-5.3L VIN P (2004)
4. Tighten the bolt in order to compress the servo cover.
5. Install the servo cover retaining ring.
6. Remove the J 29714-A from the oil pan flange.
Notice: Refer to Fastener Notice in Cautions and Notices.
7. Install the transmission oil pan bolt.
^
Tighten the bolt to 11 Nm (97 inch lbs.).
8. Install the heat shield if equipped.
9. Install the exhaust pipe assembly.
10. Install the transmission support.
11. Remove the transmission jack.
12. Lower the vehicle.
13. Fill the transmission to the proper level with DEXRON III transmission fluid.
