Envoy 4WD V8-5.3L VIN P (2004)
Important: The mating surface of the ring gear and the differential case must be clean and free of burrs before installing the ring gear.
7. Install the ring gear onto the differential case.
Important: The ring gear bolts have left-hand threads.
8. Install the new ring gear bolts.
Hand start each bolt to ensure that the ring gear is properly installed to the differential case.
Notice: Refer to Fastener Notice in Cautions and Notices.
9. Tighten the ring gear bolts. Tighten the ring gear bolts alternately and in stages, gradually pulling the ring gear onto the differential case.
^
Tighten the ring gear bolts in sequence to 83 Nm (61 ft. lbs.).
10. Install the differential side bearings by performing the following steps:
10.1.
In order to protect the differential case, install the J 8107-2 in the case on the side opposite the bearing installation.
10.2.
Installthed33790 (2)and the J8092 (1) onto the differential case bearing as shown.
10.3.
Install the differential case bearings using the J 33790 and the J 8092.
