Envoy 4WD V8-5.3L VIN P (2004)
1. Install the propeller shaft in the transfer case.
2. Align the reference marks made during removal.
Important: Ensure that the propeller shaft assembly is fully engaged into the slip yoke. The retaining ring will produce a snapping noise when the
shaft is properly engaged.
3. Install the propeller shaft to the front axle pinion yoke.
Notice: Refer to Fastener Notice in Caution and Notices.
4. Install the yoke retainers and the bolts.
^
Tighten the front propeller shaft yoke clamp bolts to 20 Nm (15 ft. lbs.).
5. Install the steering gear crossmember.
6. Lower the vehicle.