Envoy 4WD V8-5.3L VIN P (2004)
8. Pull the CV joint from the halfshaft (4).
9. Discard the old seal.
10. Place a brass drift against the cage (1).
11. Tap gently on the brass drift in order to tilt the cage.
12. Remove the first ball (2) when the cage tilts.
13. Repeat the previous step to remove all of the balls.
14. Pivot the cage (4) and the inner race 90 degrees to the centerline of the outer race (1). At the same time, align the cage windows (3) with the lands
of the outer race (2).
15. Lift out the cage (4) and the inner race.
16. Remove the inner race (1) from the cage (2) by rotating the inner race (1) upward.
17. Thoroughly degrease all of the CV joint parts.
18. Check the outer CV joint assembly for unusual wear, cracks, or other damage. Replace any damaged parts.
19. Clean the halfshaft bar. Use a wire brush to remove any rust in the seal mounting area (grooves).
Assembly Procedure
Important: Replace the joint assembly if necessary.
