Envoy 4WD V8-5.3L VIN P (2004)
18. Place the top half of the J 41048 on the bottom half.
19. Check to make sure there are no pinch points on the seal before proceeding with procedures.
20. Insert the bolts (2). Tighten the bolts (2) by hand until snug.
Notice: Refer to Fastener Notice in Cautions and Notices.
21. Align the following items:
^
The seal
^
The halfshaft bar
^
The swage clam.
^
Tighten each bolt 180 degrees at a time, using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
22. Loosen the bolts.
23. Separate the dies.
24. Check the swage clamp for any "lip" deformities. If the deformities exist, place the swage clamp back into the J41048.
Important: Ensure that the retaining ring side of the CV joint inner race faces the halfshaft bar (1) before installation.
25. Place the retaining snap ring into the CV joint Inner race.
Important: The retaining snap ring inside of the inner race engages in the halfshaft bar groove with a click when the CV joint is in the proper
position.
26. Slide the CV joint (2) onto the halfshaft bar (1).
27. Pull on the CV joint (2) to verify engagement.
