Envoy 4WD V8-5.3L VIN P (2004)
28. Slide the large diameter of the CV joint seal (1), with the large retaining ring (2) in place, over the outside edge of the CV joint outer race (3).
29. Position the lip of the CV joint seal (1) into the groove on the CV joint outer race (3).
30. Manipulate the CV joint seal (1) to remove any excess air.
31. Secure the large retaining clamp (1) to the housing with J 35910 (or equivalent), a breaker bar (3), and a torque wrench (2).
^
Torque the large retaining clamp (1) to 176 Nm (130 ft. lbs.).
32. Check the gap dimension on the clamp ear.
