Envoy 4WD V8-5.3L VIN P (2004)
2. Slide the new small swage clamp (2) and the boot (1) to the proper position on the halfshaft bar (3).
3. Position the neck of the boot in the boot groove on the halfshaft bar.
4. In order to swage the swage clamp, position the inboard end (1) of the halfshaft assembly in J 41048.
5. Align the swage clamp (2) within J41048.
6. Place the top half of the J 41048 on the bottom half.
7. Inspect to make sure there are no pinch points on the boot before proceeding.
8. Insert the bolts (2).
9. Tighten the bolts (2) by hand until snug.
Notice: Refer to Fastener Notice in Cautions and Notices.
10. Align the following items:
^
The boot
^
The halfshaft bar
^
The swage clamp
^
Tighten Each bolt 180° at a time, using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
