Envoy 4WD V8-5.3L VIN P (2004)
Back Window Regulator: Service and Repair
Window Regulator Replacement - Endgate
Removal Procedure
1. Swing the end gate open.
2. Remove the regulator bolt access plugs (3).
3. Remove the end gate trim panel.
4. Remove the end gate inner panel reinforcement.
5. Remove the end gate window.
6. Remove the bolt (3) retaining the regulator to the end gate.
7. Loosen the nuts (1) retaining the regulator rails to the end gate.
8. Remove the regulator by sliding the regulator side rails up and out of the keyhole slots (2) in the gate.
