G 1500 1/2 Ton Van V8-350 5.7L (1986)
SOLENOID VALVE AND SHIELD
MODIFICATION: MOISTURE SHIELD
The moisture shield must be modified to allow the installation of a tie strap to hold the shield to the solenoid valve. A "V" shaped slot must be cut in
both sides of the shield opposite the holed tab side of the shield (See Figure No. 3) . After the modification to the shield and solenoid bracket have been
completed, install the shield on the solenoid. Install the tie strap, P/N 15501907, tightly around the solenoid and shield (See Figure No. 4) and cut off the
excess length. Make sure that the tie strap is positioned between the center hose port and the electrical connection to the solenoid valve.
