G 2500 3/4 Ton Van V6-262 4.3L VIN Z (1992)
Installing Clutch Coil Assembly
3. Center the J 8433-1 puller crossbar in the countersunk center hole of the J 33024 clutch coil installer. Install the J 33026-2 through bolts and
washers through the crossbar slots and thread them into the holding fixture J 33026 to full fixture thickness.
4. Turn the center forcing screw of the J 8433-1 puller crossbar to force the clutch coil onto the front head. Be sure clutch coil and J 33024 installer
stay "in-line" during installation.
Staking Clutch Coil To Front Head
5. When coil is fully seated on the front head, use a 1/8" diameter drift punch and stake the front head at three places 120 degrees apart, to ensure
clutch coil remains in position.
Details Of Stakes In Front Head For Clutch Coil
^
Stake size should be only one-half the area of the punch tip and be only approximately 0.28-0.35mm (0.010-0.015") deep.
6. Install rotor and bearing assembly and the clutch plate and hub assembly.
