G 2500 3/4 Ton Van V6-262 4.3L VIN Z (1992)
Shaft Key, Clutch Plate/Hub Installation
1. Install the shaft key into the hub key groove. Allow the key to project approximately 3.2mm (1/8") out of the keyway. The shaft key is curved
slightly to provide an interference fit in the hub key groove.
2. Be sure the frictional surface of the clutch plate and the clutch rotor are clean before installing the clutch plate and hub assembly.
3. Align the shaft key with the shaft keyway and place the clutch plate and the hub assembly onto the compressor shaft.
Installing Clutch Plate & Hub Assembly
4. Remove the forcing tip on J 33013-B clutch plate and hub assembly installer-remover center screw and reverse the body direction on the center
screw.
Removing Pulley Rotor And Bearing Assembly
5. Install the clutch plate and hub installer-remover J 33013-B with bearing.
The body of the J 33013-B installer-remover should be backed off sufficiently to allow the center screw to be threaded onto the end of the
compressor shaft.
6. Hold the center screw with a wrench. Tighten the hex portion of the installer-remover J 33013-B body to press the hub onto the shaft. Tighten the
body several turns, remove the installer and check to see that the shaft key is still in place in the keyway before installing the clutch plate and hub