G 2500 3/4 Ton Van V6-262 4.3L VIN Z (1992)
2. Connect pickup coil wiring connector to module.
^
Make sure locking tab is in place.
3. Install shield onto coil.
4. Install retainer onto shield.
NOTE:
Use a new round retainer if center bushing in distributor base has no groove around the outside. Use a new square retainer when there is a
groove in center bushing.
a. Place retainer over center bushing with teeth pointing upward.
b. Place a 15 mm (5/8 in.) socket head onto edge of retainer. Keep socket centered on retainer so the teeth are not damaged. Use a small
hammer to tap retainer evenly down on center bushing. When installing square retainer, make sure both teeth are seated in groove on
bushing.
NOTE: The retainer should hold shield, pickup coil, and pole piece firmly.
5. Install shaft assembly into housing.
6. Install tanged washer, shim and drive gear (teeth up) to bottom of shaft. Align drive gear and shaft assembly.
7. Install new roll pin and spin shaft to make sure teeth on shaft assembly do not touch pole piece.
