G 2500 3/4 Ton Van V6-262 4.3L VIN Z (1992)
Pole Piece / Reluctor Wheel: Service and Repair
Typical Distributor Components
Installing Pick-up Coil Retainer
REMOVE OR DISCONNECT
1. With distributor removed, disconnect wires at module terminals
2. Remove roll pin from drive gear by driving out with 1/8 inch diameter drift punch. Mark shaft and driven gear so they can be aligned for
assembly.
3. Remove gear, shim and tanged washer from distributor shaft. Remove any burrs that may have been caused by removal of pin.
4. Remove distributor shaft from housing. Bushings in housing are not serviceable.
5. Remove retainer from inside pickup coil assembly.
6. Remove pickup coil assembly from housing.
INSTALL OR CONNECT:
1. Install pickup coil.
^
Fit tab on the bottom of coil into anchor hole in housing.
2. Connect pickup coil wiring connector to module.
^
Make sure locking tab is in place.
