G 2500 3/4 Ton Van V8-305 5.0L (1990)
Installing The Bearing
1. Bearing to the rotor and hub assembly with J 8029 and J 9481-A .
^
Place the pulley rotor and hub assembly face down on a flat surface.
^
Align the bearing to the pulley rotor and hub bore.
^
Using a center punch with a 45 degree angle point, stake 1.1-1.4 mm (0.45-0.55 inch) deep in the places 120 degrees apart.
Installing The Rotor And Bearing (Multi-Rib Type)
2. Rotor (5) and bearing (6) assembly to the compressor with J-26271-A and J 8092.
^
Position the pulley rotor and bearing assembly to the compressor.
^
Drive with J 26271-A and J 8092.
3. Retainer ring (4) with J 6083.
4. Clutch drive hub (3).
V-Belt Type
Remove or Disconnect
Tool Required:
J 25031 Rotor and Bearing Puller
