G 2500 3/4 Ton Van V8-350 5.7L VIN K TBI (1995)
Connect the negative lead to the battery body connection point (usually identified by a short # 10 AWG or larger wire running from the negative
battery terminal to the body of the vehicle).
Important:
See above important statement regarding fusing the negative power lead.
4.
Connect the positive and negative leads to the Special Equipment Option (SEO) wiring provided for this purpose (if vehicle has this option).
b.
For One Piece Transceivers (See Figure 1 - One Piece Transceiver Installation)
When ignition switch control is desired, and no SEO wiring exists, a 12 volt power contactor must be installed in the transceiver positive power
lead (See Figure 3 - Power Contactor Wiring).
The contactor (supplied by the installer) should be located near a proper 12 volt feed source.
One lead of the contactor coil should be connected through an appropriate in-line fuse to an available accessory circuit or ignition circuit not
