G 2500 3/4 Ton Van V8-350 5.7L VIN K TBI (1995)
Pull-to-Seat Connector
Pull-to-Seat Connector
1. Separate connector halves. Using proper pick or removal tool, remove terminal.
A. Pull lead gently.
B. Insert pick from front of connector into canal.
C. Pry tab up with tool.
D. Push lead to remove.
E. If terminal is to be re-used, re-form locking tang.
2. Make repair.
A. Pull terminal wire out of connector body.
B. Cut wire as close to terminal as possible.
Pull-to-Seat Connector
C. Strip 5 mm (3/26 in) of insulation from wire.
D. Crimp new terminal to wire.
E. Solder with rosin core solder.
F. Carefully pull on wire 10 draw terminal into connector body unit it locks.
Wiring Repair-SIR System
Special wiring repair procedures have been developed for use on the Supplemental Inflatable Restraint (SIR) System due to the sensitive nature of the
circuitry. These instructions are to be followed whenever servicing the SIR System wiring.
