G 2500 3/4 Ton Van V8-350 5.7L VIN K TBI (1995)
Compressor Shaft Seal
NOTICE: Seals should not be re-used. Always use a new specification service seal kit. Re sure that the seal to be installed is not scratched or
damaged in any way. Make sure that the seal is free of lint and dirt that could damage the seal surface or prevent sealing.
Install or Connect
Installing Shaft Seal O-Ring
1. Dip the new seal O-ring in clean 525 viscosity refrigerant oil and assemble onto O-ring installer J 33011.
2. Insert the O-ring installer J 33011 into the compressor neck until the installer "bottoms." Lower the moveable slide of the O-ring installer to
release the O-ring into the seal O-ring lower groove. (The compressor neck top groove is for the shaft seal retainer ring.) Rotate the installer to seat
the O-ring and remove the installer.
Lip Seal Installed On Seal Protector
