G 2500 3/4 Ton Van V8-350 5.7L VIN K TBI (1995)
Voltage Test
The test shown illustrates the same point with another type of input.
If the continuity of the wire is good, battery voltage will be found between the connector and a source of battery voltage. Again use only a Digital
Voltmeter for this test.
Testing For Continuity
Continuity Check Through A Switch
1. Disconnect the vehicle's battery.
2. Connect one lead of a self-powered test lamp or ohmmeter to one end of the part of the circuit you wish to test.
3. Connect the other lead to the other end of the circuit.
4. If the self-powered test lamp glows, there is continuity. If you are using an ohmmeter, LO or no resistance means good continuity.
Testing For Voltage Drop
