G 2500 3/4 Ton Van V8-350 5.7L VIN K TBI (1995)
Fig. 15 SIR Coil Assembly Alignment
12. Reverse procedure to install, noting the following:
a. If coil assembly becomes uncentered, refer to Fig. 13.
b. If installing new coil assembly, install pre-centered coil assembly to steering column, then remove and discard centering tab, Fig. 13.
c. SIR coil assembly wire must be kept tight with no slack while installing SIR coil assembly, Fig. 14. Failure to do so may cause wire to be
kinked near shaft lock area and cut when steering wheel is turned.
d. Align opening in coil with horn tower and locating bump between two tabs on bracket and cover assembly, Fig. 15, then seat coil assembly
into steering column.
e. Turn signal control assembly must be in neutral position when assembling steering wheel.
f.
Do not misalign steering wheel more than 1 inch from horizontal centerline.
