G 3500 1 Ton Van V8-350 5.7L VIN L 4-bbl (1985)
(53) that were removed from the frame brackets.
INSTALLATION:
Parts Specs.
Note:
When fasteners are removed, always re-install them at the same location from which they were removed. If the correct fastener is damaged or
not available, use a fastener of equal size or strength (or stronger). Use the correct torque values on all fasteners. If the above conditions are not
followed, pads or system damage could result.
1. Install bushings (40 and the new bushings 53) to the stabilizer shaft (59).
Note:
It may be necessary to clean the shaft from dirt and other contaminants. Use rubber lubricant to help slide the bushings onto the shaft.
2. Install stabilizer shaft (59) to the vehicle.
3. Install the new brackets (52), bolts (54), and washers (55).
4. Install brackets (42), bolts (43), washers (39 & 41), and nuts (38).
Torque Specs:
Nuts (38): 29 N-m (21 lbs.ft.).
