K 1500 Suburban 4WD V8-393 6.5L DSL Turbo (1994)
![background image](/gmc/k_1500_suburban_4wd/v8-393_6.5l_dsl_turbo/Page-125018.png)
Fig. 2 Fuse Rating and Color
The most common method of automotive wiring circuit protection is the fuse, Fig. 1. A fuse is a device that, by the melting of its element, opens
an electrical circuit when the current exceeds a given level for a sufficient time. The action is non-reversible and the fuse must be replaced each
time a circuit is overloaded or after a malfunction is repaired. Fuses are color coded. The standardized color identification and ratings are shown in
Fig. 2. For service replacement, non-color coded fuses of the same respective current rating can be used. Examine a suspect fuse for a break in the
element. If the element is broken or melted, replace the fuse with one of equal current rating. There are additional specific circuits with in-line
fuses. These fuses are located within the individual wiring harness and will appear to be an open circuit if blown.
AUTOFUSE
The Autofuse, normally referred to simply as "Fuse," is the most common circuit protection device in today's vehicle. The Autofuse is most often
used to protect the wiring assembly between the Fuse Block and the system components.
MAXIFUSE
The Maxifuse was designed to replace the fusible link and Pacific Fuse Elements. The Maxifuse is designed to protect cables, normally between
the Battery and Fuse Block, from both direct short circuits and resistive short circuits. Compared to a fusible link or a Pacific Fuse Element, the
Maxifuse performs much more like an Autofuse, although the average opening time is slightly longer. This is because the Maxifuse was designed
to be a slower blowing fuse, with less chance of nuisance blows.
MINIFUSE
The Minifuse is a smaller version of the Autofuse and has a similar performance. As with the Autofuse, the Minifuse is usually used to protect the
wiring assembly between a Fuse Block and system components. Since the Minifuse is a smaller device, it allows for more system specific fusing to
be accomplished within the same amount of space as Autofuses.
PACIFIC FUSE ELEMENT
The Pacific Fuse Element was developed to be a replacement for the fusible link. Like a fusible link, the fuse element is designed to protect wiring
from a direct short to ground. Though the element is easier to service and inspect than a fusible link, it has limited use and will be replaced by