K 1500 Suburban 4WD V8-393 6.5L DSL Turbo VIN S (1996)
Compressor Clutch Bearing: Service and Repair
Installing - Removing Pulley Rotor & Bearing Assembly Retaining Ring
Remove or Disconnect
1. Remove the clutch plate and hub assembly as described previously.
2. Remove rotor and bearing assembly retaining ring, using snap ring pliers J 6083.
Installing Pulley Rotor/Bearing Puller Guide
Removing Pulley Rotor And Bearing Assembly
3. Install pulley rotor and bearing puller guide J 33023-A to the front head and install J 41552 pulley rotor and bearing puller down into the inner
circle of slots in the rotor. Turn the J 41552 puller clockwise in the slots in the rotor.
4. Hold the J 41552 puller in place and tighten the puller screw against the puller guide to remove the pulley rotor and bearing assembly.
5. To prevent damage to the pulley rotor during bearing removal the rotor hub must be properly supported. Remove the forcing screw from J 41552
puller and, with the puller tangs still engaged in the rotor slots, invert the assembly onto a solid flat surface or blocks as shown.
