K 1500 Suburban 4WD V8-5.7L VIN R (1997)
Center Mounted Brake Lamp: Service and Repair
REMOVE OR DISCONNECT
-
Make sure the headlamp switch is off.
1. Rear upper garnish molding at headliner.
2. Lower rear of headliner to access electrical connector.
3. Electrical connector.
-
Attach a short piece of wire to the CHMSL connector to assist guiding the harness through the body.
4. CHMSL retaining screws.
5. CHMSL from the vehicle.
INSTALL OR CONNECT
NOTICE: Refer to Service Precautions.
1. Attach harness to guide wire.
2. Pull lamp wire through hole in roof panel using guide wire.
-
Remove guide wire.
3. CHMSL to the vehicle with screws.
Tighten
-
CHMSL mounting screws to 2 Nm (17 lb in).
4. Electrical connector.
5. Headliner.
6. Rear upper garnish molding.
