K 1500 Suburban 4WD V8-5.7L VIN R (1997)
Ball Joint: Specifications
Lower
Fastener Tightening Specifications
To Steering Knuckle Nut ........................................................................................................................................................................ 128 Nm (94 ft. lbs.)
Wear Limit
-
Be sure the vehicle rests on a level surface.
-
Raise the vehicle and support it with suitable safety stands. Support the lower control arm with a floor stand or jack as far outboard as possible
under the stabilizer shaft bracket.
NOTE:
-
The vehicle must be stable and should not rock on the floor stands.
-
The upper control arm bumper must not contact the frame.
1. Wipe the ball joints clean and check the seals for cuts or tears.
-
If a seal is cut or torn, the ball joint MUST be replaced.
2. Adjust the wheel bearings.
3. Check the ball joints for vertical looseness.
-
With the vehicle on the jack stands, place a dial indicator against the spindle to show vertical movement.
