K 1500 Truck 4WD V8-350 5.7L (1986)
PROM - Programmable Read Only Memory: Testing and Inspection
Some control modules may have problems due to cracked solder joints on the circuit board. These internal control module problems can cause the
following symptoms:
^
Failure to start or vehicle is stalling.
^
The "CHECK ENGINE" "SERVICE ENGINE SOON" or "MALFUNCTION INDICATOR" light will flash or light up, but no trouble codes
will be present.
^
Vehicle instrument panel displays may be inoperative.
^
The control module may or may not communicate with the scanner.
^
Other intermittent driveability problems.
Incorrect PROM or MEMCAL removal and replacement can create solder joint problems or aggravate an existing condition. See PROM or
MEMCAL INSTALLATION for proper procedures.
If a solder joint problem results in a "hard" failure, normal test procedures will usually pinpoint a faulty control module. Many symptoms caused
by poor solder joints in the control module result in intermittent problems, but they may be hard to duplicate during troubleshooting. Control
modules with solder joint problems are sensitive to heat and vibration. You can check for these internal control module problems in either, or both,
of the following ways:
^
Remove the control module from its mounting bracket and extend it on the harness so that you can expose it to the vehicle heater ducts.
Alternatively, use the flexible duct to route air from the heater to the control module location. Then run the engine and operate the heater at the
"MAX HEAT" position. This exposes the control module to approximately 140°F.
^
With the engine running, tap on the control module several times with your hand or finger tips to simulate vehicle vibration.
If the engine stumbles or stalls, the "CHECK ENGINE" "SERVICE ENGINE SOON" or "MALFUNCTION INDICATOR" light flashes, or any
of the previous symptoms occur, the control module may have bad solder joints on the circuit board.
