K 1500 Truck 4WD V8-393 6.5L DSL (1994)
Compressor Clutch: Service and Repair
With HD6/HR6-HE Compressor
Clutch Plate and Hub Assembly
Remove or Disconnect
Clutch Plate And Hub Assembly Removal
1. Clamp the holding fixture J 33020 in a vise and attach compressor to holding fixture with thumb screws J 33026-1.
2. With center screw forcing tip in place to thrust against the end of the shaft, thread the Clutch Plate and Hub Assembly installer-Remover J
33013-B into the hub. Hold the body of the remover with a wrench and turn the center screw into the remover body to remove the clutch plate and
hub assembly.
NOTICE: Do not drive or pound on the clutch hub or shaft. Internal damage to the compressor may result. The forcing tip on J 33013-B
remover-installer screw must be flat or the end of the shaft/axial plate assembly will be damaged.
3. Remove the shaft key and retain for assembly.
Install or Connect