K 1500 Truck 4WD V8-393 6.5L DSL (1994)
7. Pivot & (pulse) switch wire harness through steering column.
^
Switch connector to vehicle wire harness.
^
Wire protector shield (36).
8. Dimmer switch rod actuator (21) to base plate (25).
^
Lubricate with lithium grease.
9. Base plate (25) to lock housing cover assembly (19).
^
Bottom edge of dimmer switch rod actuator (24) should rest on bend in dimmer switch rod (77).
10. Lock housing cover assembly (19).
11. Screws (15). Tighten screw in 12 o'clock position first, screw in 8 o'clock position second, and screw in 3 o'clock position third.
TIGHTEN
^
Tighten screws (15) in same order to 9.0 Nm (80 lb.in.).
12. Install multi-function lever.
13. Housing cover end cap (26).
14. Do all steps, "INSTALL OR CONNECT",for "UPPER COLUMN".
Steering Column Housing Cover Components - Floor Shift
HOUSING COVER
INCLUDES:
LOCK HOUSING COVER ASSEMBLY
COLUMN HSG COVER END CAP
PIVOT & (PULSE) SWITCH ASSEMBLY
DIMMER SWITCH ROD ACTUATOR
TILT SPRING ASSEMBLY
TOOLS REQUIRED:
^
J 23653-C Lock Plate Compressor
IMPORTANT
^
Before doing any service procedures in this section, removal of Steering Wheel is needed.
IMPORTANT
^
Remove only those components necessary to do repairs.