K 1500 Truck 4WD V8-393 6.5L DSL VIN P (1995)
Power Window Motor: Service and Repair
Window Regulator Motor - Rear
Rear Door Window Regulator Assembly
Note:The power window motor can not be serviced. It is replaced as a unit with the regulator.
Remove or Disconnect
Tool Required: J 34940 Rivet Gun.
1.
Trim panel. Refer to Trim Panel. See: Body and Frame/Doors, Hood and Trunk/Doors
2.
Water deflector. Refer to Inner Panel Water Deflector.
3.
Window glass. Refer to Rear Window.
4.
Window sash.
5.
Glass weatherstrip.
6.
Regulator assembly from door.
A. Drill rivets securing the regulator to door inner panel.
B. Guide regulator assembly though rear lower hole.
Install or Connect
1.
Regulator assembly to door.
A. Guide regulator assembly though rear lower hole.
B. install rivets securing the regulator to the door inner panel using J 34940.
2.
Glass weatherstrip.
3.
Window sash.
4.
Window glass. Refer to Rear Window.
5.
Water deflector. Refer to Inner Panel Water Deflector.
6.
Trim panel. Refer to Trim Panel.
