K 1500 Truck 4WD V8-4.8L VIN V (1999)
IMPORTANT: To properly align the rear cover, J 41476 must be installed onto the rear of the crankshaft with the tool mounting bolts parallel to
the oil pan surface.
4. Rotate the crankshaft until the two opposing flywheel bolt holes are parallel to the oil pan surface.
CAUTION: Refer to Fastener Notice in Service Precautions.
5. Install J 41476 and bolts onto the rear of the crankshaft.
5.1.
Tighten the tool retaining bolts by hand until snug. Do not overtighten.
5.2.
Snug the oil pan-to-cover bolts to position the cover to the pan rail.
5.3.
Tighten the oil pan-to-rear cover bolts to 12 Nm (106 inch lbs.).
5.4.
Tighten the rear cover bolts to 25 Nm (18 ft. lbs).
6. Remove J 41476 from the crankshaft.
7. Install the rear crankshaft oil seal.
8. Install the flywheel.
