K 1500 Truck 4WD V8-4.8L VIN V (1999)
5. Connect the rear EVAP purge pipe (2) to the chassis EVAP purge pipe (3).
6. Install the chassis EVAP purge pipe (3) into the crossmember clip (4).
7. Install the fuel and EVAP pipes into the transfer case bracket clip (4 wheel drive only).
8. Install the fuel and EVAP pipes into the transmission bracket clip.
9. Install the fuel and EVAP pipes into the bellhousing stud clip (4).
10. Lower the vehicle.
11. Remove the caps from the fuel rail pipes and the engine compartment pipe.
12. Connect the engine compartment EVAP pipe (6) to the chassis EVAP pipe (3).
13. Connect the fuel feed and return pipes (1 and 2) to the fuel rail.
14. Tighten the fuel filler cap.
15. Connect the negative battery cable.
