K 1500 Truck 4WD V8-4.8L VIN V (1999)
Do not tighten the bolts.
4. Position the tool J 41364-A onto the park/neutral position switch. Ensure that the two slots on the switch where the manual shaft is inserted are
lined up with the lower two tabs on the tool.
Notice: Refer to Fastener Notice in Service Precautions.
5. Rotate the tool until the upper locator pin on the tool is lined up with the slot on the top of the switch.
-
Tighten the bolts securing the switch to 25 Nm (18 ft. lbs.).
6. Remove J 41364-a from the switch.
7. Install the wiring harness connector at the vehicle harness.
8. Install the transmission control lever to the manual shaft with the nut.
-
Tighten the control lever nut to 25 Nm (18 ft. lbs.).
9. Lower the vehicle.
10. Check the switch for proper operation. The engine must start in the P (Park) or N (Neutral) positions only. If adjustment is required.
Park/Neutral Position Switch Adjustment
Adjustment Procedure
1. Check the switch for proper operation.
2. The engine must be in the P (Park) or N (Neutral) positions only. If adjustment is required, loosen the switch retaining bolts and rotate the switch
slightly.
3. Tighten the bolts to 28 Nm(21 inch lbs.)and check the switch for proper operation.
4. Repeat the switch adjustment procedure until the engine starts when the shift lever is positioned in park and neutral.
