K 1500 Truck 4WD V8-4.8L VIN V (1999)
CAUTION: To prevent personal injury, wear safety glasses when center punching and drilling the shock absorber. Use care not to puncture
the shock absorber tube with the center punch.
1. Make an indentation 10 mm (0.4 inch) from the bottom (4) of the tube (3) using a center punch.
2. Clamp the shock absorber in a vise horizontally with the shock absorber rod (1) completely extended.
3. Drill a hole in the shock absorber at the center punch (4) using a 5 mm (3/16 inch) drill bit. Gas or a gas/oil mixture will exhaust when the drill bit
penetrates the shock absorber. Use shop towels in order to contain the escaping oil.
4. Make an indentation in the middle (2) of the tube (3) with a center punch.
5. Drill a second hole in the shock absorber at the center punch (2) using a 5 mm (3/16 inch) drill bit. Oil will exhaust when the drill bit penetrates
the shock absorber. Use shop towels in order to contain the escaping oil.
6. Remove the shock absorber from the vise. Hold the shock absorber over a drain pan horizontally with the holes down. Move the rod (1) in and out
of the tube (3) to completely drain the oil from the shock absorber.
