K 1500 Truck 4WD V8-4.8L VIN V (1999)
1. Install the rear servo assembly to the transmission case as follows:
^
Accumulator spring (14).
^
Selective pin (13).
^
Servo spring retainer (12).
^
Servo spring (111).
^
Washer (10).
^
Piston seal (9).
^
Accumulator piston (8).
^
Inner ring oil seal (7).
^
Outer ring oil seal (1).
^
Servo piston (2).
^
Bottom retaining clip (3).
^
Cover gasket (4).
^
Cover (5).
^
Bolt (6).
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the cover bolts (61).
^
Tighten the bolts to 24 Nm (18 ft. lbs.).
3. Install the transmission oil pan and filter. Refer to AT Fluid/Filter Changing.
Forward Servo Replacement
Removal Procedure
1. Lift the vehicle. Refer to Vehicle Lifting.
2. Remove the oil pan and filter. Refer to AT Fluid/Filter Changing.
3. Remove the six forward servo cover bolts, cover, and gasket.
4. Remove the following parts:
4.1.
Forward servo piston pin (5).
