K 1500 Truck 4WD V8-4.8L VIN V (1999)
10. Remove the center bearing support nuts (1).
11. Remove the center bearing support (2).
12. Remove the propeller shaft (2) from the transmission (1) or the transfer case with a rearward movement.
13. Clean all parts with an approved solvent.
14. Inspect the outer diameter of the slip yoke for burrs. Burring damages the transmission seal.
15. Inspect for twisted slip yoke splines or possibly the wrong universal joint.
16. Inspect the universal joint bearings for wear.
Replace as necessary.
Installation Procedure
1. Lubricate the slip joint splines on the propeller shaft.
2. Install the propeller shaft (2) into the transmission (1) or the transfer case.
