K 1500 Truck 4WD V8-4.8L VIN V (1999)
2.
Slide the shift shaft through the following parts:
2.1.
The 3rd/4th speed gear shift fork. Ensure that the detent reliefs, in the shift shaft, point to the front of the transmission.
2.2.
The NEW shift lever.
2.3.
The block-out bushing.
2.4.
The 1st/2nd speed gear shift fork.
2.5.
The 5th/Reverse shift fork.
2.6.
The rear case bushing and bearing.
2.7.
The shift socket.
3.
Install a NEW roll pin into the shift lever. The end of the spiral must face toward the direction of the thrust.
3.1.
Rotate the shift shaft and the shift lever/block-out bushing assembly. Ensure the roll pin holes are aligned and horizontal.
3.2.
Support the shift shaft while installing the roll pin.
3.3.
Install the roll pin flush with the shift lever.
Important:
On the S/T trucks, the shift shaft has only one hole. The C/K trucks have 2 holes on the shift shaft; use the front roll pin hole (1).
4.
Install the shift shaft and shift shaft socket and roll pin.
4.1.
Align the holes in the shift shaft socket and the shift shaft.
4.2.
Drive the roll pin flush with the bottom of the shift shaft socket.
