K 1500 Truck 4WD V8-4.8L VIN V (1999)
1.3. Slit the masking tape at the windshield edge.
1.4. Remove the windshield from the opening
1.5. Place the windshield on a clean, protected surface with the inside of the windshield facing up.
IMPORTANT: If you are using the short method, do not apply primer over the existing urethane adhesive.
2. If you are performing the extended method, apply primer to the pinchweld flange.
^
Use pinchweld primer # 3 or equivalent from GM P/N 12346284.
^
Allow the primer to dry for 10 minutes.
3. Apply glass prep primer (clear, number 1) to the sealing surface of the windshield. No drying time is needed.
Wipe any excess primer off immediately.
CAUTION: When replacing stationary windows, Urethane Adhesive Kit GM PIN 12346284, or a urethane adhesive system meeting GM
Specification GM3651M, must be used to maintain original installation integrity. Failure to use the urethane adhesive kit will result in
poor retention of the window which may allow unrestrained occupants to be elected from the vehicle resulting in personal injury.
4. Apply glass prep primer (black, number 2) to the black sealing surface of the windshield. Allow the primer to dry for 10 minutes.
