K 1500 Truck 4WD V8-5.3L VIN T (2000)
Seat Back: Service and Repair
Front Seat Back Frame Replacement
Front Seat Back Frame Replacement
Removal Procedure
1. Remove the seat from the vehicle.
2. Remove the headrest and guides.
3. Remove the seat trim panel.
4. Unsnap the lumbar cable (6) underneath the seat cushion (disconnect the lumbar wire harness if equipped with power lumbar).
5. Remove the seat back trim cover and pad.
6. Remove the lumbar assembly (or power lumbar/bolster assembly if equipped).
7. Remove the seat belt retractor.
8. Remove the inboard pivot bolt (1).
9. Remove the recliner arm attachment bolts (2).
10. Remove the frame from the vehicle.
11. Transfer all necessary components to the new seat back frame.
Installation Procedure
1. Position the seat back frame on the seat.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the recliner arm attachment bolts (2).
Tighten the recliner arm attachment bolts to 53 N.m (39 lb ft).
3. Install the inboard pivot bolt (1).
Tighten the inboard pivot bolt to 35 N.m (26 lb ft).
